Mayline K32

Istruzioni d'uso: Drain the sludge from the circuit and fi ll it with the clean water, then use a heating system cleaner as Mayline HR, Mayline HR PLUS or Mayline CP. New systems must be cleaned with Mayline Novorisan or Mayline CPL if they are already loaded with water. Calculate the water content of the system for the correct amount of Mayline K32. Half fi ll the heating system with water. Add 0.5% of Mayline K32 in new systems, while in cleaned and restored systems add 1% of Mayline K32. Then fi ll the circuit completely with water, vent it well and turn on the pumps to put the water into circulation. After about an hour (after 3-4 hours on large systems) check the concentration with the MOLYBDENUM KIT, in circuits treated at 1% the molybdenum value must be 250mg/l. Recheck the molybdenum concentration after 1 to 3 months. Mayline K32 has a long-lasting efficiency if the treatment was carried out with a 1% dosage. The molybdenum value is in any case subject to a MANDATORY PERIODIC CHECK every 12 months with the appropriate MOLYBDENUM KIT. In the event that the molybdenum value is lower than 140mg/l, it is necessary to refi ll with Mayline K32 to bring the molybdenum value beyond this minimum value. The optimal value of molybdenum is equal to 200-250mg/l for cleaned and restored systems, which guarantees a maximum protection of the system. It is recommended that the molybdenum value is checked annually and to be refilled if necessary!